COMMISSIONING
15
7. Remove the burner assembly (two 5mm wing nuts)
and chosen gas inlet plate (Fig. 33 & 34).
10. Relocate the burner assembly and mark/cut gas
pipe to length, then secure burner assembly with the
5mm wingnuts and refit the gas inlet cover plate
(Fig. 33 & 34).
11. Connect manometer to pressure test point on the
brass Pressure Test elbow and ignite the burner to
check working pressure and gas rate see (page 16).
Note: the gas rate is factory set and is not adjustable
without specialised Legend equipment.
12. Refit heat shield, gas connection cover panel must
be always fitted (Fig. 36).
Wing Nut X 2
Burner Assembly
Burner Top Grill
Rear and Base Gas
Inlet Cover Plates
Inlet Pressure
Test Point
Gas Connection
Cover Panel
Lower Controls
Heat Shield
Fig. 33
Fig. 35
Fig. 36
Fig. 34
