13
Powering Up VS 12.2
1. Power Cable:
The supplied power cable will plug into a socket on the
back terminal plate of the unit.
NOTE: Try to plug into the same AC circuit as the rest of your audio
system, as this will avoid hum from ground loops.
2. Power Switch:
The power switch is on the rear panel. Three settings
are available,
Off/Auto/On
. In the
Off
mode, the amp is turned off. In the
Auto
position, the amp will remain off until a signal is applied. After a long
period with no signal, the sub will return to its off state. The
On
position
will cause the amp to stay on all the time.
Protection
VS 12.2 features a special thermal reset to prevent damage to the internal
amplifier. This is invisible under normal operation, however should your
subwoofer be over-driven for long periods it will enter the “protect” mode
and turn itself off. Once the unit cools down normal operation is restored
by resetting the unit to
Off
, then back to
Auto/On
If you have any
questions about this please call us.
