Functional Description
The Legacy 12V battery charger is for the specific purpose of charging a Legacy 12V DC battery pack that provides power for the Legacy L1380 12V
cordless grease gun. The charger is for the initial charging for the battery pack, and recharging of the battery pack as needed during the use of the
cordless grease gun. The charger has colored indicator lights to show the charging state of the battery pack during the charge cycle; green indicates the
battery pack has been properly inserted into the cavity on the charger and has made electrical contact. Once the battery pack has charged, the red light
will go out and the green light will glow, showing the battery is continuing to receive a trickle (maintenance) charge.
Assembly
Inspect battery pack cavity in charger and remove all foreign objects and dirt from cavity. Connect charger to the proper power source. Observing the
position of the alignment boss on the battery pack, carefully insert battery pack into cavity on charger. Do not force. The slot in the charger cavity must
align with the raised boss on the battery pack.
CHARGER OPERATION:
The battery pack is not fully charged out of the carton.
Read and understand all of the safety instructions, and then follow the battery charging
instructions that follow.
• Make sure power cord circuit voltage is the same as that shown on the charger. Connect charger to the power source and the green “Off” light
illuminates.
• Place battery pack in charger cavity. Do not force. The slot in the charger must align with the raised boss on the battery pack. When proper contacts
are made, the red light will appear.
•
Charge the battery for one full hour including quick-charge time prior to initial use.
• When the battery pack is fully charged, the red light will go out and the green light will glow. The battery pack will continue to receive a trickle
charge. Remove the battery pack from the charger.
• Disconnect charger power cord from the power source when not charging battery pack.
•
Important: Battery pack temperature will increase during and shortly after use.
The battery pack may not accept a full charge if charged
immediately after use. For best results, allow the battery pack to cool to room temperature before charging.
• Once the battery pack has received the necessary charge, insert battery pack into cavity of tool handle, the slot in the tool handle must align with
the raised boss on the battery pack. The battery pack will latch into the tool handle when fully inserted. Press tool trigger briefly to check for tool
operation.
SAVE THESE INSTRUCTIONS
WARRANTY*
LEGACY MANUFACTURING COMPANY (“LEGACY”) warrants that this equipment will be free from defects in material and workmanship for a period
of one (1) year from the date of purchase, under normal use. *LEGACY’S sole obligation under this warranty is limited to replacing or repairing, free of
charge, any equipment that proves to be defective under normal conditions and use according to the recommendations of LEGACY. To obtain repair or
replacement, the equipment must be shipped to a LEGACY authorized Warranty and Service Center during the warranty period, transportation charges
prepaid, with proof of date of purchase. In the event of repair or replacement, the warranty period shall not be extended beyond the original warranty
period.
While necessary maintenance or repairs on your Legacy equipment
can be performed by any company, we recommend that you use only authorized
Legacy service centers. Improper or incorrectly performed maintenance or repair voids this warranty. Contact us at [email protected] for ordering,
installation instructions.
