OPERATION
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off”
position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles
occur on any connection there may be a leak.
If you smell gas or a leak is discovered turn the
gas valve off, disconnect propane gas tank and do not use the appliance until the leak is
repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion
you must replace the hose (if applicable).
temporary condition. Emitter screen will become a bright red due to the heat. The color is more
To Light
1. Turn on the valve on the gas supply cylinder.
2. Press and turn the variable control knob to the ‘HI’ position.
3. Press down the variable control knob and hold for 30 seconds.
4. While holding down the variable control knob, press the igniter button several times until the
5. If a new tank has just been connected, allow at least
one minute or more for the air in the gas pipeline to
purge out.
6.
viewing hole located on the base of the burner.
7. Turn the variable control knob to the ‘LO’ position for
5 minutes or more before turning the knob to desired
variable control knob to the ‘LO’ position.
8.
out by wind, turn off the heater and wait at least 5
minutes or more to let the gas dissipate before lighting
again to avoid possible gas explosion. Repeat steps 2
through 4.
Variable control
knob
Igniter
To Extinguish
1. Turn control knob clockwise to the “off” position.
2. Close the cylinder valve on the propane gas tank if you don’t intend to use it for a long time.
OFF
HI
LO
IGNITER
Page 11
Summary of Contents for CAPH-7-S HB
Page 14: ...WARRANTY CONTACT Page 14 ...