3
1
2
Stopper A
(marked #049000)
Stopper B
(marked #049001)
Washer C
4
Dimple on valve stem
Notch
Stopper A
(marked #049000)
6
5
REMOVE CAP ONLY, KEEP THE REST OF
THE MUD GUARD AS IT IS NEEDED TO
HOLD THE TRIM FIXING SCREWS.
Water outlet
Water outlet
Hot water
supply pipe
Cold water
supply pipe
84mm~109mm
4
Steps 1-6
Installation Procedure
Lefroy Brooks always recommends that plumbing products be installed by a licensed professional.
Shut off main water supply before installation.
1
While placing the valve into the wall, make sure that the distance between the wall surface and
the back of the valve is between 84~109mm as the figure indicates.
2
Connect the valve with water pipes.
3
Throw away the protective cap only when the building construction is completed and you are
ready to fit the trim kit in.
REMOVE CAP ONLY, KEEP THE REST OF THE MUD GUARD AS IT IS NEEDED TO HOLD THE TRIM
FIXING SCREWS.
4
Temperature Limiting Device: Remove washer C, then take off stopper A & B.
5
Turn the valve stem so that the round dimple on the stem is at the top side.
6
Install stopper A onto valve stem. Notch on stopper A should point upward.
