lefeirc RCbro SPARROW 3-OSD, Manual, Page: 7 / 10

RCbro ®
SPARROW
3-
OSD
LefeiRC www.lefeirc.com/
*OSD menu item <GPS> can set whether to display the latitude and longitude information.
*The GPS icon will continue to flash when GPS is not connected or GPS is not fixed.
*‘>’ means to turn right, ‘<’ means to turn left, and the number after it indicates the specific
required turning angle.
*If the RC icon flashes, it means that the RC is failsafe or the receiver is disconnected. If the GPS
has been fixed at this time, it will automatically switch to the RTH.
➢
CONTROL OSD MENU
Enter Menu Quickly dial CH5/CH6
Exit AIL LEFT
Enter AIL RIGHT
UP/DOWN ELE UP/DOWN
➢
PARAMETERS
FRAME T-TAIL 、 V-TAIL 、 WING
INSTALLATION
InstallDirection
ROLL/PITCH/YAW
GAIN
Set the gain, the YAW gain only works in ACRO .
ROLL/PITCH/YAW
DIRECTION
Set the output directions of servos.
RC CALI Calibrate the RC
LEVEL CALI
LEVEL CALI
VOL/CURRENT CALI Set voltage/current offset.
CRUISE SPEED Flight speed in RTH.
RTH ALT
SAFE ALT
In RTH, if the distance is beyond 3 times the circling
radius, the min flying altitude is <SAFE ALT> . If it is
higher than this altitude, it will slowly descend; after
approaching the HOME, the fly altitude is <RTH ALT>.
FENCE RADIUS If the distance exceeds this radius, RTH will be triggered.
RTH RADIUS Circle radius.
MODE 1/2/3
The flight mode corresponding to each position of the
mode channel(CH5/CH6).
ACRO GAIN Stability gain in ACRO.
VEL GAIN
The faster the speed, the smaller the required gain, and
the larger <VEL GAIN> should be.
AUX1-6
[1]
Set AUX function(AXU3-6:CH1-4)
AUX1-6 DIRECTION Set the output direction of the AUX.
GPS Whether to display latitude and longitude.
TELE MAVLINK:MAV1-57600, MAV2-115200,CRSF telemetry
RSSI
RSSI
MODE-CH
Select mode channel
HOS/VOS Set OSD offset.
THR-DIFF
[1]
Throttle differential ratio controlled by YAW.
MANUAL
[1]
Sticks control ratio in ACRO mode.
PORT
[1]
PWM:CH1-4 is PWM receiver channel.
AUX:CH1-4 is AUX3-6.
GPS RESET
[1]
GPS RESET
LANGUAGE Chinese and English.