RCbro
®
SPARROW
3-
OSD
[1]Since the FC has undergone an upgrade, these setting items are added later. If your FC does
not have it, don't worry, it will not affect your flight performance.
*When setting the AUX function, RC6-12 means the remote control 6-12 channel.
*< FENCE RADIUS
>
only works in fence mode, other modes do not have fence function.
*After changing the <TELE>, you need to restart the FC.
*After changing the <PORT>, you need to restart the FC. If it is set to AUX, the AUX3-6 setting
items will be automatically added after restarting.
➢
Flight Summarize
After land, OSD will show summarize about flight info.
Quickly dial mode channel(CH5/CH6) to exit.
➢
LED
GREEN
Quick flash
RTH/ALTHOLD/FENCE
Flash
MANUL/ACRO
On
STAB
RED
Flash
GPS NoFix
On
GPS Fixed
Off
NO GPS
➢
GPS
The FC supports UBLOX protocol, but does not support NMEA. After power-on, the FC
will automatically configure the GPS. If the FC cannot recognize the GPS latitude and
longitude, you can reset the GPS through the setting item
<GPS RESET>
.
Flight Mode
➢
How
MAN
The airplane is direct controled by RC.
STAB
Control the angle of airplane,and auto level when no RC input.
ACRO
Gyro mode,lock the current angle when no RC input.
ALT
Hold current height when no ELE input.
FENCE
Auto Retun Home when out of fence radius.
RTH
Auto Retun Home.
* FENCE and RTH can only be used when the GPS is fixed, otherwise it will become the ALT.
➢
Assisted Takeoff
ALT/FENCE:
Push the throttle to enough power, after takeoff(throw it away), the aircraft will
climb to 20m automatically.
RTH Mode:
Push the throttle to enough power, shake the aircraft or run, then the motor starts
slowly, and then take off after the power is enough(throw it away), the aircraft automatically
climbs and circles over HOME.
➢
Throttle control
MAN/STAB/ACRO/ALT:
Throttle is direct controlled by RC.
FENCE:
Before triggering RTH, the throttle is controlled by RC, after triggering, it is determined
by RTH.
RTH:
Throttle is controlled by RC during assisted takeoff, after entering the circling state, the
throttle is controlled by the FC, it automatically adjusts the throttle according to the cruise
speed you set, you can manually push the throttle up (beyond the throttle calculated by the
FC) to increase cruise speed, but you can't pull it down.
➢
Throttle differential
When an AUX port is set to throttle, and the <THR-DIFF> is not zero, then you can
control the differential rotation of the two motors by YAW channel. It is necessary to pay
attention to whether the direction of the speed change of the two motors is correct, if it is