Leev jack, User Manual

Page: 19 / 27

19
JACK - User Manual JACK LJ 1.0 2015-1/INT EN
Chapter 6.
USING THE BATTERY
For your safety and the safety of others, and to maximize battery life
and performance, follow the instructions in this manual.
Do not use the batteries if the casing is:
- Broken
- Emits an unusual odor or excessive heat
- Leaks any substance
Avoid contact with any substance seeping from the batteries.
Keep Batteries out of reach of children and pets. Exposure to Battery
voltage could result in death or serious injury. Unplug and disconnect
your JACK from AC power before removing or installing Batteries or
performing any service. It is hazardous to work on any part of your
JACK when it is plugged into AC power. You risk serious bodily injury
from electric shock as well as damage to your JACK. The cells within
the Battery contain toxic substances. Do not attempt to open the Bat-
tery. Do not insert any object into the Battery or use any device to pry
at the Batteries casing. If you insert an object into the Batteries’ port or
openings you could suffer electric shock, injury, burns, or cause a fire.
Attempting to open the Batteries casing will damage the casing and
could release toxic and harmful substances. Only charge the Battery
using charging devices approved by LEEV Mobility. Comply with all
local and federal and individual country laws when disposing or and
transporting the JACK Batteries.
The JACK has 1 battery in its foodboard. For charging
the JACK you will need a JACK charger (included). Fol-
low these simple steps for charging:
6-1: charging components
1. Place your JACK in a dry environment within the
recommended charging temperature range.
2. Make sure the main switch (RFID) is off.
3. Verify that the charge port, power cord and AC
power outlet are clean, dry and free of debris.
4. Plug the connector into the charge port of the
JACK.
5. Plug the charger into a AC power outlet or
surge protector.
Charging takes about 5 hours for a full charge. During
charging, 1 red LED is lit on the charger. When the bat-
tery isfully charged, the LED turns green. After charging,
unplug the connector from the charge port. The JACK
is ready to go!