Leetop Leetop-FLAME-NX, Manual, Page: 23 / 26

引脚 Pin 信号名称 Signal 引脚 Pin 信号名称 Signal
61 GND 62 NC
63 NC 64 3V3
65 NC 66 3V3
67 GND
功能介绍 Software /BSP
系统配置 Software configuration
NVIDIA Linux For Tegra (L4T)
Flame-NX
支持原生 NVIDIA Linux For Tegra （ L4T ） Builds 。 HDMI 、千兆以太网、 USB3.0 、 USB
OTG 、串口、 GPIO 、 SD 卡、 I2C 总线均可得到支持。
详细说明和工具下载链接： https://developer.nvidia.com/embedded/linux-tegra
Flame-NX supports native NVIDIA Linux for Tegra (l4t) builds. HDMI, Gigabit Ethernet, USB3.0,
USB OTG, serial port, GPIO, SD card, I2C bus can be supported, and can run directly on A502
without any change. Please note that the native system does not support PWM mode to
control the fan. If the native system is used, ipcall-bsp must be deployed. LT4 can be
downloaded from the following link:
https://developer.nvidia.com/embedded/linux-tegra
注：原生系统并不支持 PWM 方式控制风扇，如果使用原生系统必须部署 IPCall-BSP
Note: The native system does not support PWM control of the fan, if you use the native
system you must deploy IPCall-BSP
NVIDIA Jetpack for L4T
Jetpack
是一个 NVIDIA 发布的软件包，包含了在 Jetson 开发所需要的各种软件工具，包含主机端和
目标机端各种工具，包括 OS 镜像文件，中间件，示例程序，文档等内容。
详细说明和工具下载链接： https://developer.nvidia.com/embedded/jetpack
Jetpack is a software package released by NVIDIA, which contains various software tools
needed for TX1 / TX2 development using a501, including host side and target side tools,
including OS image files, middleware, sample programs, documents, etc. The latest jetpack
runs on Ubuntu 14.04 Linux 64 bit host and can be downloaded from the following link:
http
s://developer.nvidia.com/embedded/jetpack
默认配置系统 Default configuration system
Leetop-FLAME-NX 盒子采用 Ubuntu 18.04 系统，默认用户名： nvidia 密码： nvidia
Leetop-FLAME-NX box with Ubuntu 18.04, default username: nvidia password: nvidia