Door/Window Sensor Installation Guide
Door/Window sensors are designed to secure the perimeter of the residential premise and provide the ability to
add various automation services. The Door/Window sensor, which consists of a magnet that attaches to a door or window, will
communicate door events to the home security system. When the magnet is moved away from the sensor, a signal will be sent to
the control panel that communicates the changed state to the security system. Signals can also be used to activate a chime or
convenience lighting based on system settings.
Frequency
2.4GHz
Battery Type
CR2 Battery, Jauch P/N - 245718
Operating Temperature
0
C to 50
C (32°F - 122°F)
Storage Temperature
-20
C to 60
C (-4°F - 140°F)
Battery Life
5 Years
Dimension
Sensor Device: 80.4mm x 23.1mm x 23.2mm (3.17" x 0.91" x 0.91")
Magnet: 35.1mm x 12.3mm x 13.4mm (1.38" x 0.48" x 0.53")
Spacer: 3mm and 6mm (0.12" & 0.24")
The Door/Window sensor needs to be paired before installation.
1.
While next to the home controller or security system slide the top cover open to expose the battery pull tab, pull the plastic
tab to activate the sensor, slide the top cover to the closed position, Figure 1.
2.
The LED indicator will be lit green for two seconds while the
device is booting.
3.
Once booted the LED will blink green three times every 5
seconds while scanning for a network.
4.
If network is not found after 10 minutes, the sensor will go
into sleep mode. To restart the pairing process, tamper the sensor
by sliding the battery cover open and then closed or create a zone
event by placing the magnet near the sensor and then move it more
than 3” away from the sensor.
5.
Once the device has successfully paired to the home controller or security system it
is
ready for installation, follow the
steps in the installation section.
1.
Once paired the LED will blink either a red, green
,
or amber color providing a visual indicator of the communication
performance with the home controller or security system. Move the sensor to the intended location of installation. If the
LED is slowly blinking green you have good communication with the home controller or security system and can proceed
with the remainder of the installation process. Double blinking amber indicates the sensor can communicate, however, look
at improving the communication by alternating the location of the sensor on the door or window. Fast blinking red indicates
the sensor cannot be installed at this location.
Note:
The LED will illuminate for 3 minutes after the initial pairing process, if additional time is needed to position
the sensor slide to the top cover open and then closed and the LED will illuminate for an additional 30 seconds.
2.
Please make sure that the sensor and magnet is located less than 0.25 inch from each other. For optimal performance, it is
highly recommended to install the Door/Window sensor on the fixed frame and the magnet on the moving part of the
door/window. Place the sensor near the top of the door/window close to the opening edge of the door/window. When
Introduction
Specification
Installation
Pairing Sensor
