PRIMER FEED WASHER SHIPS WITH YOUR TURRET PRESS. PRIMER FEED BRACKET SHIPS WITH SAFETY PRIME
TURRET PRESS PRIMER FEED INSTRUCTIONS
2
INSTALL appropriate
primer arm. Cycle up and
down to insure proper
orientation.
*
SMOOTH OPERATION TIP
*
Spent primers are extremely dirty, and after extended use it
may be necessary to clean ram where primer lever is inserted.
Clean the ram using gun scrubber, electrical contact cleaner
or disc brake cleaner. Be sure to lubricate outside of ram with
#30 weight motor oil or equivalent.
CHANGING primer sizes can be done in seconds!
• Replace L-shaped primer arm with appropriate size
• Substitute appropriate feed assembly
8
SELECT correct primer feed
assembly
small
black trigger assembly
large
white trigger assembly
SLIDE primer feed into case
feed bracket.
Snug bolt with 1/2” wrench.
SLIDE the tray flow control
valve to ON
9
DE-PRIME and
size case as normal.
With ram at the top
of the stroke (handle
down), push trigger
on the primer feed to
dispense a primer.
NOTE
Trigger has to be
fully forward, then down
to dispense primer.
��
LOWER ram (raise handle) to seat primers. The primers
should be flush to slightly below flush when properly seated.
7
SLIDE the flow control to lock, and slide
trough and tray together, making sure that the
trough is completely seated.
1
INSTALL primer feed bracket using supplied
washer and bolt as pictured. Orient bracket with
feeder installed to lever prime. Lightly tighten bolt
with 1/2” wrench.
CLASSIC
TURRET
PRESS
6
Shake tray side to side to
upright all the primers. Close
cover.
3
Slide the flow control
OPEN
5
Flip tray over to
deposit the primers.
4
Unfold tray and
place on top of box of 100
primers.
LARGE
BP2889B
SMALL
BP2889A
TURRET PRESS USERS
If using the Case Activated Powder Measure,
the riser should be installed to give sufficient
clearance between the primer tray and powder
measure body.
RISER
catalog #90041
