Lee Jackson XLS-1000P, Quick Start Manual

Page: 2 / 3

Operation:
Input - Instrument Input
Preamp - Controls the input gain or sensitivity or the amplifier.
More - adjusts the amount of gain (distortion) to be added to the original signal.
Treble - Controls treble response.
Middle - Controls mid-range response.
Mid-Shift -
(Position 1 is “off”)
This control has 6 preset positions to give you the ability to select
the right overall mid frequency of your amplifier. Position 2 enhances high mids, position 6
enhances low mids. Positions 1-2-3 will make a thick sounding guitar or pickup sound thinner,
whereas positions 4-5-6 will make a thin sounding pickup sound thicker. We recommend starting
on position 3 and adjusting to taste (for cleanest sound use position 1-2).
Masters - Is a presetable output level controls. These masters are selectable, use "MASTER I" to
bring down (cut) the overall volume of the pedal. You can set "MASTER I" for a rhythm volume
then footswitch to "Master 2 for a boosted lead volume.
Feedback - The Feedback adds re-genitive signal, which adds depth and tightens the response,
just like it does in a real, some of the very vintage amps did not use Feedback.
Speaker Emulator – Because the XLS-1000P is a direct copy of XLS-1000 amplifier, it would
sound without emulation just like it was coming out the “Line out” of the amp. And it does with
the Emulator Off. Use the emulator when you want to direct record into your favorite recording
system. The Speaker Emulator changes the output to sound just like a 4-12 cab, with a SM57 in
front of it.
Foot Switches:
Bypass - Switches overall pedal signal, "READY" (green) is the standby switch that allows the
pedal to idle , and True Bypass the input signal to the “Output Jack”. "GO" (red) is when your
ready to engage and hear the full sound of the XLS-1000P.
Effects Loop - The Loop Footswitches an outside loop of your favorite effects, it is after the
Master controls, so how you have them set effects the Effects Loops level. Use a stereo cord to
include your outside loop of effects, “Tip” is send (output) and “Ring” is Return (input).
More - adjusts the amount of gain (distortion) to be added to the original signal.
Masters - Select output level controls.
The XLS-1000P pedal operates on a single 9-volt battery; the power supply jack on the side of
the pedal can be from 9 –12 vdc at 500 ma or up. The tip is negative.