The lamp house
The lamp has three power modes controlled by the switch on the back of the
lamp house. Push the power buCon during 1 second to turn on
respecEvely turn off the light. It always lights up at the lowest power. To
switch between power modes press the buCon for about 1/10 second. If you
use the maximum power you need to be moving outdoors so the lamp gets
sufficient cooling. You have to move around with about 5 -‐ 7 km / h
depending on outside
temperature. If the light becomes warmer than 75 ° C, it automaEcally drops
to a lower power, first to 40% and if the high temperature persists aUer 2
minutes it drops to 10%.
The lamp is water resistant, but should not be used underwater.
Ba<ery indicator
A baCery indicator in 4 steps built into the lamp. To acEvate the baCery
indicator; hold the power buCon for about 4 seconds. You will receive a
number of flashes that tell you how long you can use the light before it's
over, see table. Only works on the back baCery.
The Emes are approximates and are affected by baCery condiEon and
temperature. When the baCery is almost depleted the lamp is automaEcally
reduced to the lowest power. Then there are about 60 minutes leU on low
power before the baCery is completely depleted. If you have drained the
baCery so much that it goes down to 10%, you should charge the baCery as
soon as possible aUer using the lamp.
Number of
flash
Power mode
100%
Power mode
40%
Power mode
10%
4
>2h 55 min
> 8h 45 min
> 27h
3
> 1h 45 min
> 5h 30 min
> 17h 30 min
2
> 50 min
> 2h 45 min
> 8h 45 min
1
< 50 min
< 2h 45 min
< 8h 45 min
Sida 3
Summary of Contents for Cobra IIx
Page 1: ...Cobra IIx English...
