Product number
Operating voltage
Power consumption Protection
class
Protection
type
LC-L-252-W
230 volts 50 Hz
18 watts
IP65
LC-L-252-WW
230 volts 50 Hz
18 watts
IP65
Moisture-proof LED light – Installation instructions
07/2020
Subject to technical modifications.
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.ledscom.de, Tel. +49 (0) 21 61-5 75 99 76
Protection against penet-
ration of dust, protection
against water jets
IP65
Protection class 2: Double
insulated, protected against
electric shock by touch
Figure 2
Mounting plates
1
Screws
Dowels
2
3
Not dimmable
Figure 1
Anschlusskabel
3
1
2
N
Brown
Blue
Please read these installation instruc-
tions carefully before installing the socket
and keep it for future reference.
1. Safety instructions
The installation of the light may only be performed by a
trained electrician.
Only use this product, if it works correctly. In the case of
a fault, do not touch the product. Switch off the product
immediately by an external switch. Touching the product
or continuing its operation in the event of a fault results in
danger to life due to burn, electrical shock or fire.
How to detect a fault:
• the product does not work correctly (e.g. flickering of the
lamp, cannot be switched on)
• the product smokes, crackles or smells burnt
• the product overheats (discolouration, even on the
adjacent areas)
Operate the product again only after repair and testing
exclusively by a trained electrician!
2. Intended Use
This light may:
• only be operated at a voltage of 230V ~50 Hz.
• only be connected according to protection class II (2).
• only be used according to protection rate IP65.
• only be operated if mounted firmly on a robust, flat
bottom.
• not be exposed to strong mechanical stress.
• not be changed or modified.
The product is not intended for use by children. Make sure
that the product does not cause any damage to children,
e.g. burn by hot surfaces, electrical shock.
If the lamp is not used in accordance with these require
-
ments, especially if moisture enters the lamp, it results in
danger to life due to burn, electrical shock or fire.
3. Maintenance and care
The following environmental influences can have undesira-
ble effects on the surface of the product:
• cleaning agents
• other chemical substances
Protect the product by appropriate measures to avoid
changes to the surface.
First disconnect the whole product from the power supply
and let it cool down before cleaning and care. Clean the
product regularly - only by a slightly moistened, soft,
lint-free cloth.
4. Storage
• The product has to be stored under dry conditions, pro
-
tected against contamination and mechanical impact.
• After a humid or contaminated storage the product has
to be tested by a trained electrician before operating.
5. Disposal (European Union)
The product must not be disposed of with the
household waste. Products marked with this symbol
have to be disposed of under the terms of the EU
Waste Electrical and Electronic Equipment (WEEE
2012/19/EU) Directive by local return centres.
6. Installation instructions
1. De-energize the mains lead of the building by discon-
necting the building wiring fuse and protect it against
reconnection.
2. Drill two holes (6 mm Ø) and insert the supplied dowels
(3) there. Make sure that the dowels are flush with the
wall.
3. Screw the mounting plates (1) directly onto the moun-
ting base using the screws (2) and dowels (3) supplied.
4. Then place the lamp with light pressure on the moun-
ting plates (1) until they engage firmly.
5. Connect the lamp to your house wiring as shown in
Figure 2. Switch the power back on. The installation is
now complete.
