www.prolight.co.uk
Slimline 7HEX6 Series
User Manual
10
Operating instructions
Optional IR remote functions:
Button functions:
DMX address examples:
Important notes:
•
Set the DMX address on each fixture before plugging into the DMX controller
•
The IR remote is cannot be used when the fixture(s) are being controlled by a DMX controller
•
The maximum transmitter distance is 10m - Please make sure that you have the IR remote aimed
directly at the front panel of each fixture to be programmed
•
If you do not press the “DMX MODE” button after you have changed the DMX address,
when you power down the fixture it will lose the address you have set
01 - Set the LEDs into power on or off modes
02 - Set in auto run
03 - Run the built-in programs, then use the ‘+’ and ‘-’
buttons to go through the programs
04 - Set the LEDs to flash on and off, then use the ‘+’
and ‘-’ buttons to change the flash frequency
05 - Set the run speed, then use the ‘+’ and ‘-’ buttons
to change the desired speed (note: only available in
the colour change or colour fade modes)
06 - Set the LEDs into DMX mode
07 - Set the LEDs into sound active mode
08 - Set the LEDs into slave mode
09 - Set the DMX address for the LEDs
10 - Set the LEDs colour, then use the ‘+’ and ‘-’
buttons to change the brightness
1 2 3
4 5 6 0
+
_
7 8 9
AR
D
FL
SL
SP
S
S PR
SA
R
G
B
W
A
UV
BLACKOUT
DIMMING
FLASH
SLAVE
SPEED
SET ADDR
SELECT PROG
SOUND ACTIVE
AUTO RUN
DMX MODE
03
01
04
10
02
05
07
08
06
09
To set the DMX address “245”;
•
Press the “S” button, the red LEDs will come on,
you can now start to set the DMX address
•
Now press the “2” button, the green LEDs will
come on, this means the first digit has been
set at 2
•
Now press the “4” button, the blue LEDs will
come on, this means the second digit has been
set at 4
•
Now press the “5” button, and all of the
R, G, B, A, W and UV LEDs will come on,
the third digit 5 has been set. The full DMX
address setting has been changed
•
Now press the “DMX MODE” button to save
the new address into the memory
To set the DMX address “002”;
•
Press the “S” button, the red LEDs will come on,
you can now start to set the DMX address
•
Now press the “0” button, the green LEDs will
come on, this means the first digit has been
set at 0
•
Now press the “0” button, the blue LEDs will
come on, this means the second digit has been
set at 0
•
Now press the “2” button, and all of the
R, G, B, A, W and UV LEDs will come on,
the third digit 2 has been set. The full DMX
address setting has been changed
•
Now press the “DMX MODE” button to save
the new address into memory
Optional
IR remote
Order code:
LEDJ90F
