Operations:
1). Auto run mode
To set the unit in the Auto run mode, press the
“MODE”
button to show
“AUTO RUN MODE”
on
the LCD display. Now press the
“SETUP”
button and use the
“UP”
and
“DOWN”
buttons to
select your desired speed setting. Press the
“SETUP”
button for a second time to select the
desired flash frequency using the
“UP”
and
“DOWN”
buttons.
Speed setting: 00-99 (00=slow, 99=fast)
Flash frequency: 00=99 (00=low, 99=high)
2). DMX Addressing mode
To access the DMX address mode, press the
“MODE”
button to show
“DMX512 MODE”
on the
LCD display. Now press the
“SETUP”
button to set the desired DMX address from 001-512 using
the
“UP”
and
“DOWN”
buttons. Follow the DMX channel assignment and function table below.
In this mode the CT (Colour Temperature) displays the actual colour temperature set by the DMX
controller. Once you have set the DMX address, cycle through the other operating modes back to
the DMX mode. The unit will now remember your DMX address setting.
3). Slave mode
Link the units together using a 3-pin XLR DMX cable, then press the “
MODE”
button on the slave
unit(s) to show
“SLAVE MODE”
on the LCD display. The Slave units will now follow in sequence
with the Master unit.
4). Dimming mode
In this mode you can set the desired light output of any of the two colours (white or amber)
to create a dynamic static colour.
First press the
“MODE”
button to show
“DIMMING MODE”
on the LCD display. Press the
“SETUP”
button to set the desired light output for the white LEDs
using the
“UP”
and
“DOWN”
buttons. Now press the
“SETUP”
button for a second time to set the desired light output for the
amber LEDs
using the
“UP”
and
“DOWN”
buttons. Finally press the
“SETUP”
button for a third
time to select the desired flash frequency using the
“UP”
and
“DOWN”
buttons.
White LED Output: 00-99 (00=low, 99=full)
Amber LED Output: 00-99 (00=low, 99=full)
Flash frequency: 00=99 (00=low, 99=high)
Note: Always press the “SETUP” button a final time to confirm the setting.
5 Channel DMX chart
LEDJ Omni WA-36
Operation
