www.prolight.co.uk
EasiLED 4 DMX Controller
User Manual
7
Operating instructions
13) Auto mode button:
Select User/Bank mode then press the Auto button to activate Auto mode for scene/chase playback.
Playback speed in Auto may be controlled by either the Tap/Temp or the Speed control.
14) Sound mode button:
Select User/Bank mode then press the Sound button to activate Sound mode for scene/chase
playback. To adjust the internal microphone sensitivity, press and hold the Sound button and use
the fade control.
15) Strobe button:
The Strobe function can be made active in all modes across the controller. Press the Strobe control
button to activate Strobe mode, the red LED will illuminate to confirm Strobe mode is active. The control
for strobe is latching and will remain active until the button is pressed a second time.
16) 3-Pin DMX output:
3-Pin XLR socket output. Pin 1 = Ground, Pin 2 = data –ve, Pin 3 = data +ve
17) DMX start address:
The controller has preset DMX start addresses for each of the four fixtures. Please set your fixture to the
following DMX addresses. Please note: If two or more fixtures are set to the same DMX address they will
receive the same DMX commands. The controller can be setup to address four individual 3 channel RGB
fixtures addressed sequentially (001, 004, 007 and 010) or if the fixtures feature RGBW or RGB with a
Dimmer channel they can be addressed with sufficient spacing between the fixtures to account for the
extra channels (001, 017, 033 and 049).
18) DMX channel selection:
The controller can be used to control up to four fixtures from RGB through to RGBW+Dimmer. Slide the
switch to the position suit the fixtures being used. Please note: To operate correctly, all fixtures should
share the same DMX channel allocation.
19) Internal microphone/external audio select:
The controller can be triggered either via the internal microphone or from an external line level
audio source.
20) Audio input:
Unbalanced 6.35mm (1/4”) jack socket for line level audio input.
21) DC power input (ve):
Centre positive type connection. 9-12VDC, 300mA minimum regulated type.
22) Power on/off switch:
Use this switch to power the controller on/off.
