7
black,
or brown,
or grey
center:
yellow/ green
blue
Caution!
Place and lock the dome not in unmounted state.
The dome can be loosened due to the seal and the bad
grip of the base plate difficult.
Disconnect the power supply for the connecting cable.
fig. 1:
Hold bracket against the wall and mark drill points, drill the holes, insert the
dowel. Use suitable material for wooden walls or lightweight walls.
Pull the cable through the cable grommet.
Put one sealing ring on each screw and fasten the base plate with the
3 screws.
Watch out for a proper seal and the correct position of all seals, in order to
ensure the splash water protection (IP44).
fig. 2:
Prepare the current-less cable in according to statutory regulations.
Connect the wires according the marks.
fig. 3:
Put on the dome to the base plate and lock it with a short turn right
(bayonet locking system).
Switch on the power supply.
fig. 2
fig. 3
fig. 1
Installation
Important NOTE!
LED luminaires are generating high inrush current peaks. In addition to
the described mounting conditions (see supplementary sheet: Important information for the
installation of LED luminaires)
max. 8 pieces
of this luminaire should be installed in one circuit.
Other loads, such as motors, should not be installed in this circuit.
