2
301 Thor Place, Brea, CA 92821 |
tel
(714) 256-2111 |
fax
(714) 256-2118 | [email protected] |
www.ledconn.com
Details are subject to change without notice. © 2019 LEDCONN CORP. All Rights Reserved.
IG.20.01.R0
I N S T A L L A T I O N G U I D E
SCAN FOR
DIGITAL VERSION
MOUNTING
We recommend utilizing the 3M adhesive with metal screw fasteners to securely mount LUXFLEX.
PART I: APPLY THE 3M ADHESIVE
•
To obtain maximum adhesion, bonding surfaces must be stable, smooth,
clean, and dry. Make sure the surface is clear of debris and is not greasy. Firm
application pressure develops better adhesive contact and helps improve bond
strength.
•
1/32 inch spacing between LUXFLEX Flexible LED Sheets is required to avoid
conductor contact between flexible sheets.
•
For best application, LEDCONN recommends bonding surfaces that are non-
greasy and debris-free. 3M tape adheres best to metal, plastic, and painted
surfaces.
1)
Dry Fit
With the 3M adhesive tape backing still on, dry fit the LED flexible sheets
to to ensure proper fitment in enclosure. Avoid repositioning LUXFLEX after peeling
off the adhesive tape. 3M adhesive is very strong, but it will lift and cause the sheet to
wrinkle. Conducting the dry fit mockup before removing the adhesive peel will help
greatly.
2)
Solvent Wipe
To obtain optimum adhesion, the bonding surfaces must be cleaned
and smooth. Most substrates are best prepared by cleaning with a mixture of isopropyl
alcohol (IPA) and water.
3)
Wipe Dry
Wipe dry the bonding surface.
4) Remove 3M adhesive tape backing and apply to surface. Use all tape on the
back.
5) Apply firm pressure to improve adhesive contact and bond strength; however,
avoid applying pressure to the LED.
PART II: SCREW IN THE METAL FASTENERS
•
Screws are to only be fastened inside the ellipsoidal holes marked on the
sheet. Use only round screw heads such as pan or truss.
Do not use tapered screws such as countersunk, wood, or drywall.
•
1/32 inch spacing between LUXFLEX Flexible LED Sheets is required to avoid conductor contact between flexible sheets.
1) Position the LED flexible sheet in the desired mounting location and use the factory supplied ellipsoidal mounting holes as a template to drill
into the mounting surface. Only drill through the designated mounting holes, and do not penetrate through LED flexible sheet substrate.
2) Fasten screws through the LED flexible sheet mounting holes ensuring the screw head is securing the LED flexible sheet to the mounting
surface.
ADD SCREWS TO THE HOLES.
SCREW SHOULD BE FLUSH
AGAINST MOUNTING SURFACE.
MOUNTING TIP
To prevent hotspots, we recommend
installing LUXFLEX
at least 3-4" away
from the diffuser or illuminated surface.
LUXFLE X
™
Static White & RGBW
FLEXIBLE SHEET
