3/5
IMPORTANT INSTRUCTIONS
Ÿ
Growing Plant Material
APPLICATIONS
FLEX STRIP CONNECTION
-
Wire connection using WAGO block connectors
Class 2 Power Source
Alpha XLD Series
AC120V
LED Flex Strip
WAGO
Cut instructions
-
Solder Connection Points
Solder connection points are at marked intervals.
Cut points are at every 6 LEDs (24VDC)
Note Polarity Marks
100mm
+
+
+
+
-
-
-
-
+
-
-
INSTALLATION PLANNING
LED Flexstrip is a versatile lighting product that can provide a superior lighting solution in a variety of applications.
Recommend design steps before starting the installation process:
General questions based on lighting requirements:
Ÿ
Where will your power supply be located
Ÿ
How will you switch your LED lighting ON and OFF?
Ÿ
What is the best layout conguration for your installation with wiring consideration?
Ÿ
How will you run your wiring to your LED strip lighting?
WIRING FOR VOLTAGE DROP
Voltage drop is normal loss of voltage that occurs as power ows along a wire connection in a low voltage systems, and increases as the length of a wire connection is
increased. Wire length and thickness as well as total light wattage inuence the amount of voltage drop.
Recommended maximum wire lengths - 24VDC
Wire Guage (AWG)
20 AWG
18 AWG
16 AWG
20W
30W
50W
60W
90W
100W
27 FEET
42 FEET
67 FEET
45 FEET
28 FEET
18 FEET
11 FEET
9 FEET
6 FEET
5 FEET
8 FEET
9 FEET
14 FEET
17 FEET
27 FEET
22 FEET
15 FEET
13 FEET
WATTAGE CALCULATION
The LED Flex Strips have a label on each roll that indicates the voltage and wattage. You must have the correct Class 2 voltage Power Supply (Transformer) for LED Strip
model. To calculate the wattage, measure the total length of LED Strip in your run multiplied by the wattage of the LED Strip. Remember that a power source should only
operate at a maximum 80% of it rated capacity.
For example
: 10 feet of HH-SRB60F010-2835 x 4W = 40 Watts
Never Extend the Length of rolls. Rolls are sold in there max length.
IMPORTANT NOTE
Mount Strips on Clean (No Wax/Oil), dry,
smooth, burrows free surface
Download Magnitude app for voltage drop calculations:
Android App
iOS App
Note
: The LED Grow Strip™ must not be farther than 24” (0.6 meter) from the plant. Ideally plant should be 2”-3” (5cm-7cm) away from the Grow Strip
™
.
NANO COATED LED GROW STRIP
™
1-800-387-4081
ledworldlighting.com ledworld.ca
Model:
HH-SRB60F010-2835
Copyright © 2017 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 2.5 - 06/06/17
