background image

4/4

Apply 1 ½” long electrical heat shrink over all connection points. Secure connection wire with wire clamp. 
Note: Diagram below shows 2 wire, but RGBW strip will have 5 wires 

IMPORTANT !

 

Wrong!

4"

(100mm)

On widest one flat plane (only)

Do not bend sideways. 

Flexible on one axis

maximum band radius 4”

TROUBLESHOOTING 

Tape light strip does not light

Ÿ

Confirm you have the correct polarity (+ to +, G to G, R to R, B to B and W to W) throughout the run of LED Lighting.

Ÿ

Have a electrician check all connections and any switch or dimmer connections from the power supply to the LED Light Strips.

Ÿ

Consider testing with a multimeter to ensure light strip is receiving 24V power. 

LED Flex Strip lights blink on, then go off

Ÿ

The power supply is not adequate for the length of LED Light Strips you are powering. Install a adequate Class 2 power supply.

Ÿ

Make sure your power supply is turned on and has the correct voltage.

Ÿ

This is the result of voltage drop. Decrease the length of the 24V power feed or use thicker power feed wires between the 24V power supply 
and the lighting strips.

LEDs farthest from the power supply are noticeably dimmer

MAXIMUM FLEXSTRIP LENGTH SUPPORTED BY LED WORLD’s CLASS 2 POWER SUPPLY

NOTE:

It is recommended to mount our RGBW LED flexstrip with Aluminium profiles, as Aluminium profiles acts as a heat sink. 

NOTE: This model of RGBW LED Strip has pigtail connectors on both ends. Use only one connector end and remove the additional end 
connector wire  if entire roll is used before attaching to power supply. Otherwise there is possibility of short circuit that may create a serious 
hazard and damage. This additional wire at the end of the roll is provided to make it easier to connect if the strip is cut. Do not attach an 
additional roll to end wire. The roll size (10m/32.8ft) is the maximum length that can be attached to a regulated class 2 power source. 

IMPORTANT !

 

+

-

-

-

+

-

Cut Mark

Pigtail Connector

Pigtail Connector

IMPORTANT INSTRUCTIONS

  

 

1-800-387-4081

 

ledworldlighting.com ledworld.ca

 | 

 

LONG RUN RGBW LED FLEX STRIP

  

Model

: FA60M51-10M-24V-RGBW

Copyright © 2021 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).

LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.1 - 10/18/21

Power Supply

Max Feet of LED Flexstrips

Power Supply

Max Feet of LED Flexstrips

28.50 Feet (Continuous 77 Watts)

MD-024-096VTDHV2

MD-024-060VTDHV2

17.77 Feet (Continuous 48 Watts)

MD-024-192VTHD52JV2

2 X 28.50 Feet (Continuous 77 Watts
each channel)

MD-024-288VTHD52JV2

3 X 28.50 Feet (Continuous 77 Watts
each channel)

Summary of Contents for FA60M51-10M-24V-RGBW

Page 1: ... not curl or twist and roll out completely straight before applying power Ÿ Only qualified electrician or engineer can perform installation familiar with low voltage wiring techniques Correct polarity is imperative is marked on printed circuit Parallel connection only Ÿ DO NOT install on flammable material or possibility of in the future Do not install any luminaire closer than 6 inches 15 25 cm f...

Page 2: ...ng to your LED strip lighting Ÿ Where will your power supply be located WATTAGE CALCULATION Never Extend the Length of rolls Rolls are sold in their max length For example 10 feet of FA60M51 10M 24V RGBW x 2 7W 27 Watts The LED Flex Strips have a label on each roll that indicates the voltage and wattage You must have the correct Class 2 Power Supply Transformer for LED Strip model To calculate the...

Page 3: ...G R B W G R B W G R B W G R B W W 24V R G B Optional DMX LED Controller Class 2 Power 24VDC GND 24V RGBW Flex Strip W B R G W RGBW LED STRIP CONNECTION Low Voltage Polarity marks must match otherwise strip will not work IMPORTANT NOTE 1 800 387 4081 ledworldlighting com ledworld ca LONG RUN RGBW LED FLEX STRIP Model FA60M51 10M 24V RGBW Copyright 2021 LED WORLD INC All Rights Reserved We are not r...

Page 4: ...W LED flexstrip with Aluminium profiles as Aluminium profiles acts as a heat sink NOTE This model of RGBW LED Strip has pigtail connectors on both ends Use only one connector end and remove the additional end connector wire if entire roll is used before attaching to power supply Otherwise there is possibility of short circuit that may create a serious hazard and damage This additional wire at the ...

Reviews: