2/4
FLEX STRIP CONNECTION
-
Wire connection using WAGO block
connectors
Class 2 Power Supply
AC120V
LED Flex Strip
WAGO
Cut instructions
-
Solder Connection Points
50mm (1.96”)
-
-
-
-
Solder connection points are at marked intervals.
Cut points are at every 3 LEDs (12VDC)
Note Polarity Marks
+
+
-
-
INSTALLATION PLANNING
LED Flexstrip is a versatile lighting product that can provide a superior lighting solution in a variety of applications.
Recommend design steps before starting the installation process:
General questions based on lighting requirements:
Ÿ
How will you switch your LED lighting ON and OFF?
Ÿ
Where will your power supply be located
Ÿ
What is the best layout configuration for your installation with wiring consideration?
Ÿ
How will you run your wiring to your LED strip lighting?
WATTAGE CALCULATION
The LED Flex Strips have a label on each roll that indicates the voltage and wattage. You must have the correct Class 2 Power Supply (Transformer) for
LED Strip model. To calculate the wattage, measure the total length of LED Strip in your run multiplied by the wattage of the LED Strip. Remember that
a power source should only operate at a maximum 80% of it rated capacity.
For example : 10 feet of FA60M28-5M-12V-X x 2.2W = 22 Watts
Never Extend the Length of rolls. Rolls are sold in there max length.
Polarity marks must match
((+) to(+) and (-) to (-))
otherwise strip will not work
IMPORTANT INSTRUCTIONS
WIRING FOR VOLTAGE DROP
Voltage drop is normal loss of voltage that occurs as power flows along a wire connection in a low voltage systems, and increases as the length of a
wire connection is increased. Wire length and thickness as well as total light wattage influence the amount of voltage drop.
Recommended maximum wire lengths - 12VDC
Wire Guage (AWG)
20 AWG
18 AWG
16 AWG
20W
30W
50W
60W
90W
100W
13 FEET
21 FEET
34 FEET
22 FEET
14 FEET
9 FEET
5 FEET
4 FEET
3 FEET
3 FEET
4 FEET
5 FEET
7 FEET
8 FEET
13 FEET
11 FEET
7 FEET
7 FEET
Download Magnitude app for voltage drop calculations:
Android App
IOS App
LED Strip is equipped with 3M self-adhesive tape. Mount strips on clean (no wax/oil), dry, smooth, burrows free surface. Adhesion can be
made once and LED Strip must fully adhere to surface.
Use Aluminum profile or aluminum heat sink tape to avoid overheating ,
ensure proper heat dissipation and
extend the life of the LED
MOUNTING NOTE
-
-
-
-
°C
BRIGHT PLUS LED STRIP LIGHT
Model
: FA60M28-5M-12V-X (X = COLOR W:Neutral White / WW:Warm White / R:Red / G:Green / B:Blue)
1-800-387-4081
ledworldlighting.com ledworld.ca
|
Copyright © 2021 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 4.2 - 10/14/21
