www
.
LED
tronic
s
.c
om
Brackets Installation
© 2010 LEDtronics, Inc.
LED
TRONICS, INC.
®
THE FUTURE OF LIGHT
9001:2000
ISO
CERTIFIED by DNV
INSTR-SLL003P
-0001-E / R
ev
. 02/2011
Mounting Arm
6”, 12” or 18” with a
square or round pole
®
Mounting Arm
For Luminaire Mounting
Screws
PAGE 3
SLB003-FLEM6S-001
(Square Poles)
SLB003-FLEM12S-001
(Square Poles)
SLB003-FLEM18S-001
(Square Poles)
SLB003-FLEM6R-001
(Round Poles)
SLB003-FLEM12R-001
(Round Poles)
SLB003-FLEM18R-001
(Round Poles)
Place gasket square (part 3) over
■
mounting location of luminaire
and over desired mounting
location surface.
With flat side of the mounting
■
bar, screw the screw bars into the
luminaire.
Mount luminaire and arm in
■
desired location over the gasket
square. Utilize washers and nuts
as in figure on right.
External Mount
Slipfitter
SLB003-FL73SFX-001
Open luminaire lens by
■
removing 4 screws.
Remove outside of cord grip
■
by sliding an adjustable
wrench on the inside and
with an additional wrench
on the outside rotate to
loosen. Remove only the
outside of cord grip. Leave
inside of cord grip located
inside the luminaire.
Reinstall Luminaire lens with
■
4 screws.
Open luminaire arm
■
and loosen arm screw to
gain access to luminaire
mounting screw holes.
Run power cord through
■
arm.
Insert screws, place square
■
gasket over screws and screw
into luminaire enclosure.
Rotate pole section of arm
■
to desired angle and tighten
arm screw to secure.
Loosen pole mount screws
■
and mount onto the pole.
Tighten screws and secure.
