LED CREATIVE - BYTE User Manual v4.0
5
figure 4
5
6
7
8
1
2
3
4
1
2
3
4
5
6
7
8
BYTE CONT ROLLER
OK
BYTE RECEIVER
BYTE SETUP - 24 Volt version
Use this wiring setup for any cable run on LED Creative
SIGMA Fairground fittings between 5-20 metres.
Maximum of 20 fittings per output, 160 per controller.
Note about serial based pixels
Our pixel products are serial data based on a cascading data transmission. Each time a Dmx frame is received they display
the information received and continue to display that information until a Dmx frame containing different information is
received. If the Dmx is unplugged the last received Dmx frame will continue to be output by the Leds. Power cycling the box
(with no Dmx data connected) will clear all outputs.
Test mode
To test controller outputs with no DMX present:
SETTINGS [ENTER]
None
All white 20%
All white 50%
All red
All green
All blue…
RGB alternating - good test mode for rigging as you can see that all pixels are responding and continue to respond
as the product is rigged.
The test mode logic is that a Dmx signal automatically overrides any active Test patterns.
