DMTH4
LECTROSONICS, INC.
32
Outputs Tab
This tab is used to set the output levels for the TEL,
CODEC or AUX channel outputs from the DMTH4. If
connected to a DMTH4, changes made in this tab take
effect immediately. As always, the changes are not
permanent unless the DMTH4 settings are stored to a
preset in nonvolatile memory.
Output Channel
Mute
Comp/Lim
Level Meter
Gain Control
Attenuation Control
Output Channel
TEL
CODEC
Mute: Checkbox to control if the output is muted (checked) or unmuted (unchecked).
Comp/Lim LED: Glows yellow to indicate that the compressor for the corresponding output
channel is active or red to indicate that the channel is in limiting.
Gain control: Displays the selected output channel’s gain in dB. Gain can be adjusted from
-69dB to +20dB, or set to “Off”. There are two ways to change the gain:
Click the up or down buttons next to the control
Type a value directly into the control and press ENTER
Level meter: True RMS level meter which displays the output audio level in dBu as meaured
after application of the
main and rear panel output channel gains, but before the signal is
processed by the output filters, compressor/limiter, or mic level attenuator. The meter range
is -40dBu to +20dBu.
Same as TEL with the exception of Attenuation Control
Name
Description