Lectronics D4, Instruction Manual

Page: 8 / 16

D4T/D4R
LECTROSONICS, INC.
8
System Setup Steps
The following steps are necessary to set up and oper-
ate the D4 system. Details for each step are on the
next pages.
1) Attach antennas and power supplies to the trans-
mitter and receiver.
2) Tuning Menu - select the same operating frequen-
cy on the transmitter and receiver.
3) 2/4 Channel Mode - set 2-channel or 4-channel
modes the same on transmitter and receiver.
4) Select the AES3 modes on transmitter and receiv-
er as needed for the connected equipment, mixer,
recorder, etc. (see AES3 Modes)
5) Adjust audio input levels on the transmitter. (see
Transmitter Audio Level Setup)
6) Adjust audio output levels of analog outputs on the
receiver. (see Receiver Audio Level Setup)
7) Walk test the system to check for adequate op-
erating range. If dropouts occur within the range
needed, select a different operating frequency.
System Setup
Tuning Menu
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
Use UP/DOWN
arrows to select
channel, then
press FUNC to
return to menu
2/4 Channel Modes
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
Use UP/DOWN
buttons to select
desired mode
AES3 Modes
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
Use UP/DOWN
buttons to select
desired mode
Audio Level
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
NOTE: The setup screens for Audio Level on the
transmitter and receiver will be slightly different.
See the next page for details.
Locked/Unlocked Modes
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
Use UP/DOWN
buttons to select
desired mode