4PSXXIVXIWXW
%P]WQEMRXIRERGIQERYEP
%%
):JMPPVIWIVZSMV
1.
Click the “EV fill reservoir 1” button. The corresponding LED (on the
command screen) should turn red. The solenoid valve is now supplied.
2.
Unplug the connector on the solenoid valve being tested and then plug it
back in. Each time the connector is plugged back in, you should hear the
switch click on the solenoid valve.
3.
When the test is complete, plug the solenoid valve back in and click on
the “EV fill reservoir 1” button on the Alys Expert command screen. The
corresponding LED should go out.
):JMPPVIWIVZSMV
1.
Follow same procedure as above (
):JMPPVIWIVZSMV
7KHVROHQRLGYDOYHVWREHWHVWHGGHSHQGRQWKHPDFKLQHW\SH
:KHQWKHPDFKLQHGRHVQRWKDYHDOOWKHVROHQRLGYDOYHV$O\V$O\V/
$O\V $O\V/WKHFRPPDQGVFRUUHVSRQGLQJWRWKHVHQRQH[LVWHQW
VROHQRLGYDOYHVDUHJUD\HGRXW
:IRXMRK
1.
Same test procedure as for the other solenoid valves (see above).
*MPPTYQT
7KLVWHVWZLOOFKHFNWKHURWDWLRQGLUHFWLRQRIWKHSXPSPRWRU,IWKHSXPS
PRWRULVWXUQLQJLQWKHZURQJGLUHFWLRQWKHLQNFLUFXLWFDQQRWEHVXSSOLHG
!
7KLVWHVWPXVWQRWEHGRQHXQOHVVWKHSXPSLVEHLQJUHSODFHG7KH
WXEHVKRXOGQRWEHSODFHGLQWKHSXPSWRGRWKHWHVW
1.
Make sure the tube is not placed inside the pump to be tested.
2.
Click the “Fill Pump” button. The LED opposite the button should light
up and the pump should be working.
3.
Check which way the pump is turning (anti-clockwise).
4.
If the pump is turning in the wrong direction, reverse the black and red
wires used to power it.
5.
When the test has finished, click the “Fill Pump” button again. The LED
opposite the button should go out and the pump should stop working.
6.
Put the tube back in the pump.