Squiggles TT User Manual p.7
The Targeted Trainer has
been designed to fit with
a pivot chassis.
8.2 Attaching stander
to pivot chassis
To attach the stander to
the Pivot Chassis, pull the
locking pin out , slide
the central spine into the
receiving bracket until it is
fully engaged, release the
pin allowing it to snap
back into place.
Always make sure the locking
pin is fully engaged before
you place the child
in the stander.
8.3 Attaching the horizontal
support
To attach the Leckey
Horizontal Support first open
the locking lever by pressing
the safety button and pulling
the handle . Then slide
the stem into the receiving
bracket on the central spine,
set to the desired position
and secure using the locking
handle.
The angle adjustment plate
allows the angle of the
stander to be changed and
set.
To adjust the plate loosen
the bolts with the Leckey
tool provided.
Slide the plate along the
slots until it contacts the
upright support at the
desired angle.
The position of the assembly
can be adjusted up the
spine. However this should
only be necessary if the
spine assembly is adjusted.
The plate position relative to
the chassis should always
be as shown.
