pg 3
OPERATION INSTRUCTIONS
1. Open the lid and add water to the unit. Do not overfill the unit. Water
may be added up to the “Full” line marked on the inner pot of the
unit. Note: do not drench the outside of the unit when adding water.
2. Close the lid after adding water.
3. Place the unit on a clean, stable surface and plug the unit into an
outlet. Once the unit is plugged in the power indicator light will
illuminate and heating will commence. The red “Heating” light
indicates that the unit is heating the water. The water will be heated
to a boil. The unit will then automatically switch to “keep warm”
and the heating light will go off, the “keep warm” light will then be
illuminated. If the water in the unit drops below the set temperature,
the unit will automatically switch back to “heating” until the water
reaches the set temperature. CAUTION: Steam from the steam vent is
hot, use caution around the unit when in use.
4. Press the “unlock” button.
5. Place cup under dispense spout and press the “dispense button” or
manually dispense water by pressing the “manual pressure” on the
top of the unit to dispense water. Once water has been dispensed
(about 10 seconds later) the unlock indicator light will go off and the
unit will lock again.
6. Note: If an empty inner pot is heated, the overheat safety function (which
prevents an empty inner pot from being heated) will be activated, the
power will be shut off automatically to prevent the problems that can
occur due to overheating, the power will be on automatically when the
temperature declines. When the inner pot is heated with no water in it
or with the water level below the low water level mark, a bad smell may
be caused or the inner pot may become discolored. Please observe the
following:
• Do not connect the power without pouring water into the inner pot.
• Do not boll water when the level is below the Low water mark.
• After water is added, do not leave the lid open.
7. CAUTION: Please often check the water level in the inner pot. Under normal
status, if an inner pot is being heated with no water in it very often or for a long
time, the inner pot will become discolored, a smell may be caused due to the rising
temperature of the main unit, the temperature fuse may be broken, and even
worse, a fire may be caused.
8. After Use Pull out the power plug from the outlet. Pull out the power plug
from the main unit. Detach the lid. Drain the water from the drain mark until
you can see the drain mark. No water should be left in the inner pot.
