Lec TF55207W, User Manual

Page: 8 / 24

Location
When selecting a position for your unit you should make sure the floor is flat and firm, and
the room is well ventilated with an average room temperature of between 16°C and 43°C.
Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct
sunlight as it may increase the electrical consumption. Extreme cold ambient temperatures
may also cause the unit not to perform properly. This unit is not designed for use in a garage
or outdoor installation. Do not drape the unit with any covering.
Levelling the Unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the doors and magnetic seal alignments
will not be covered properly.
Free Space Requirements
When installing the unit, ensure that 25
mm of free space is left at both sides, 50
mm at the rear and 25 mm at the top
of the unit. The door can be opened to
the right or the left, depending on what
better suits the location.
Please ensure there is more than twice
the width and depth distance space
of the unit to fully open the door to a
maximum angle of 160°.
Max. 160°
Y mm
X mm
7
INSTALLATION
1. Remove the 2 rear spacers and the 4 screws from the accessory bag.
2. On the back of the appliance at the bottom on both sides of the compressor
area there are pre-drilled holes. Fix the 2 rear spacers to both sides of the
compressor area into these holes using the 4 screws that are provided.