Installation:
IMPORTANT: If the appliance has not been stored or moved in an upright position,
let it stand upright for approximately 12 hours before operation. If in doubt allow the
appliance to stand.
1. Remove the appliance from the packaging. Make sure that all protective plastic film and
coatings are thoroughly removed from all surfaces.
2. Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for
ventilation. Increase this distance if the obstacle is a heat source.
3. Set the brakes on the castors to keep the appliance in position.
4. Before using the appliance for the first time, clean the shelves and interior with soapy
water.
Removing the Compressor Safety Band:
The compressor is located on the top of the appliance, and sits on rubber washers. Under
normal operating conditions the compressor is allowed to vibrate. To avoid damage
through excessive motion during transit, a stainless steel safety band is placed over the
compressor and screwed into the top of the appliance. This safety band and the two
screws fixing it to the appliance
MUST BE REMOVED
before the appliance is turned on.
Lock/Unlock the Doors:
A lock is fitted to the doors to ensure foodstuffs are kept secure within your appliance.
Use the keys provided to lock/unlock the door.
Fitting the Shelves:
1. Place one set of shelf guides on either side of the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
Changing the Door Hinge:
The door can be changed from right hand-hinged to left hand-hinged, or vice versa.
1. Remove the top hinge pin, lift off the door, remove the bottom hinge pin.
2. Fit the bottom hinge pin on the desired side.
3. Place the door on the bottom hinge pin, fit the top hinge pin.
