www.lec-commercial.co.uk
6
Electrical Connection
The appliance is intended for connection with alternating current. The connection
values for voltage (V) and frequency (Hz) are declared on the name plate in the
cabinets. Power must be connected via a wall socket with a switch. It is strongly
recommended that the wall socket is accessible. The cabinet plug and wall socket should
give correct earthing. If in doubt, please contact your local supplier or an authorised
electrician.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
If this appliance is fitted with a non-rewirable plug for which your socket is unsuitable
the plug should be cut off and an appropriate plug fitted. The removed plug must be
disposed of as insertion of the plug into an electrical socket is likely to be dangerous.
WARNING:
THIS APPLIANCE MUST BE EARTHED
If a non-rewirable plug or a rewirable 13 Amp (BS 1363) plug is used it must be fitted
with a 13 Amp ASTA approved (BS 1362) fuse. If any other plug is used, please contact
our Spares department for details on appropriate fuse type.
The wires in the mains lead are coloured in accordance with the following code:
Note: These colours may not correspond with the coloured markings identifying the
terminals in your plug.
Do not
push excess mains lead into the compressor compartment.
If it is necessary to change the fuse in a moulded plug and the fuse cover is detachable, it
must be refitted after the fuse has been changed. If the fuse cover is lost or damaged the
plug must not be used until a replacement is obtained.
It is important that the colour of the replacement fuse cover corresponds with the
coloured insert or as indicated in embossed words on the base of the plug. Replacement
fuse covers are available from our Spares department, at the address on the final page of
this manual.
2
GREEN AND YELLOW
- EARTH
BLUE
- NEUTRAL
BROWN
- LIVE
