7
5) If the glass canopy has not been
pre-assembled by the factory, it should
be fixed to the top of the main body of
the cooker hood at this stage.
6) Lift the main body of the cooker
hood towards the angle bar and fix it
into position using the 16 x M5 screws.
IMPORTANT: This stage of the
installation process MUST be
completed by two people.
IMPORTANT: The 16 x M5
screws MUST be securely tightened.
7) If you are going to be using the
hood in extraction mode, you should
fix the ducting hose to the ceiling.
The electrical connection must correspond to the electrical requirement
noted on the rating plate, which is placed inside the cooker hood. The
appliance should now be connected to the electrical supply.
Check that the appliance is operating correctly by selecting each speed and
switching the light bulbs on and off.
Remove the hanging hook and then slide the lower chimney section
downward until it rests against the main body of the cooker hood.
Use a stainless steel cleaner and polish the stainless steel sections of the
appliance.
If you are using the appliance in recirculation mode, you should now fit the
carbon filter. See the “fitting the carbon filter" section.