6/10 PWL III
Insert the cable and lock it on the PWL III
Install the audio transmitter. (no transmitter holder is provided).
Connect the cable to the transmitter.
Adjust the transmitter sensibility.
Verify that all elements are firmly assembled.
SWITCHING ON/OFF
There is no on/off switch on the PWL III.
The audio transmitter automatically powers on and off
PWL III.
After switching on the transmitter,
PWLIII
enters a fast initialisation mode by
flashing red then blue LED. Then the
48V
''
BLUE
'' LED should
blink
slowly as
the microphone is powered.
LED DISPLAY
OFF -
the transmitter is off.
BLUE
slow blinking (3sec.)-
the microphone is powered with 48V.
RED
slow blinking (3sec.)-
the battery is low, 1 hour left .
RED
fast blinking (1 sec.)
- the battery is very low, 15 mn left.
Times given may vary upon type of battery and microphones used.
RED
full –
The battery is too low to power the microphone.
PWLIII
stops the
power conversion to preserve Nimh battery from over-discharge.
Lebel Audio
www.lebel-audio.com
