STEP 2:
Connect the H-Bridge with the Arduino. (Refer the Getting Started Manual)
STEP 3:
There are 4 pins in Line Following Sensor. Vcc (+5V), GND, A0 and D0.
Make the Connections between Arduino & Line Following Sensor as follows:
Line Following Sensor
Arduino
Vcc
5V
GND
GND
D0
Digital Pin 3
STEP 4:
Startup ArduBlock (Refer Getting Started Manual for Installation). Build the Code as follows:
1.
Select a “do loop” panel from the “Control”
tab.
2.
Select “set digital variable” from “Variables/Constants” tables and snap it as shown.
Summary of Contents for CODI BOT
Page 1: ......