TROUBLESHOOTING
SYMBOL OR
PROBLEM
CAUSE
SOLUTION
OR
the display is
empty.
Battery needs to
be replaced or the
polarities of the
battery are in the
wrong direction.
Replace with a CR2032 battery
(a standard watch battery). Also
try inserting the battery in the
correct alignment.
Data needs to be
uploaded.
Perform an On Demand upload.
Steps not
counting
correctly.
The Fitbug is attached
incorrectly, the stride
length is incorrect or
the display is in the
wrong mode.
Ensure you are wearing your
Fitbug as recommended. Check
your stride length. Refer to the
display options section of this
manual for more instruction.
Data is not
appearing on
LEAP4LIFE
website.
Data is not uploading
Confirm: 1) Computer is on; 2)
It is connected to the Internet;
3) Dongle is inserted; 4) Fitbug
software is running; 5) Fitbug is
with 15m of computer; 6) You’ve
taken at least 200 steps.
Upload using the On Demand
method. If it does not appear,
contact
CHANGING THE BATTERY
Your Fitbug utilizes a CR2032 3V battery, which comes pre-installed.
If your battery is running low, you’ll see the
icon indicating it is
time to replace it.
When you replace the battery, or the open the battery compartment,
all data in the Fitbug will be reset.
Be sure to offload your data before
changing the battery to preserve your activity records.
To replace the battery:
1.
Use a small Phillips screwdriver to remove the battery
compartment lid. Once opened, keep the screws in a safe place
to avoid losing them.
2.
Remove the old battery and insert the new one, matching the
polarities (+/-).
3.
Replace the lid by screwing it back into place.
You will need to reset your stride length, weight and local time after
replacing a battery.
Summary of Contents for Fitbug
Page 1: ...WELCOME GUIDE...
Page 11: ......
