6
Assembly
4
5
6
7
5
3
4
12
2
3
4
5
10
10
12
Slide the two (2) Centre Rails (part 5)
into the two Frame Ends (parts 3 &
4) ensuring: a} the slots in the Centre
Rail (part 5) face inward b} the slots
in the Centre Rail (part 5) are closer
to the top edge when the assembly
is upside down (see inset).
For each leg assembly, attach a Foot (part 2) with
four (4) M6x10 Machine Screws (part l 2) and tighten
in a cross-pattern.
Check both sides of the desktop before placing
the desk base on the underside of the desktop.
Adjust the width of the desk base to fit the
desktop by sliding the two halves outward.
We recommend leaving at least 1/2” of the
desktop width (on each end) protruding
beyond the frame width and centring the
side brackets (part 6) before and after.
Lock the position of the Centre
Rail (part 5) using eight (8) M6x10
Machine Scews (part 12).
Ensure the M6x10 Machine Screws
(part 12) contacts the Centre Rail
(part 5) by sliding the Centre Rail
(part 5) as needed.
