Installation Steps
S4
G
L
S5
B:Find the corresponding position on the car body as shown, use 4 S3( big
flat head tapping screws 4*12mm) to fix the G(front axle) into this
position. (Note: the L(steering yoke) need to be pointed at the Steering
hole ). Put the S5(M8*16 gasket)on the L(Steering yoke) first, then fix it
by S4(M8 nut).
S3
step2:Install the rear axle
First press and firm the K(rear suspension pivot) into the corresponding
position as shown. Then press the A(rear axle) through the hole as shown
in figure (Keep the same length on both sides ).
step3:Install the front and rear wheel
A. Install the front wheel: Install the B(front wheel) into the G(front axle),
two S1(M8*22 gasket) need to be placed out of the B(front wheels) and
securely fix them with S4(M8 nut).
B. Install the rear wheel: Install the C(rear wheel) into the both sides of
the A(rear axle). (Note: the convex side of the C(rear wheel) is inside)
then put two S1(M8*22 gasket) out of the C(rear wheels) securely fix
them with S4(M8 nut).
C. Press and fix 4 D(Wheel cover) onto the corresponding position on
wheels.
S4
S4
S1
S1
D
D
S4
S1
D
D
S4
S1
C
C
B
B
G
A
7
8
A
K
A: Use K(M8 spanner) to loosen S4(M8 nut) , one on L(steering yoke), two
on G(front axle) ,and two on A (rear axle), then take off S5 (M8*16
gassket) and S1 (M8*22 gasket).(Note: Front axle need to retain two
gaskets, as shown in figure)
step1:Install the front axle
S4
S4 S1
S1
S4
S5
G
A
S4 S1
S4
S1
