8
Now that your Snap valve controller is
attached
to your valve,
it will require a calibration to determine its position and know
whether you have a gate or ball valve.
To calibrate,
simply press and hold both the open and close
buttons on top of the controller for 10 seconds.
Then,
let go.
Once you release the buttons, the LEDs turn on
solidly and
simultaneously
for a couple seconds. This indicates that the
calibration sequence has been initiated.
Let the valve complete its calibration cycle – expect
approximately 3 full valve movements, consisting
of open/close cycles.
After completion, verify calibration success:
SUCCESS:
Open and close LEDs flash steadily
simultaneously before turning off and staying off.
FAILED:
Open and close LEDs flash rapidly
simultaneously. Then, the open LED stays on as
during power up.
Note:
If you paired your LeakSmart Snap before
calibration, you will not be able to open/close your
device from the LeakSmart App.
Warning:
If at any time during calibration that the snap valve
controller, while actuating, shifts off the pipes axis, quickly
remove all power to stop the motion. Use the quick release to
remove snap from the pipe then revisit fine adjustment
step 5.
TO RESET:
To reset the snap valve controller back to factory
settings - press and hold the sync button for 15 seconds.
Press and hold
for 10 seconds
Add
Devices
9
Now you are ready to pair your Snap to your
LeakSmart System.
Note:
If you haven't already activated your
LeakSmart Hub, download the LeakSmart App
through the Apple App Store or Google Play to begin
Hub setup. The Hub must be activated first before
other devices can be added. To pair the Snap
controller to the LeakSmart hub, follow the in app
paring instructions, when tapping on, Add Devices.
6
Remove the battery compartment door and install the
four(4) AA batteries in the battery holder.
Note:
The snap
valve controller will not go into calibration mode
(Step 8)
when running on battery power alone. The AC power cord
must be plugged in,
see step 7
.
Batteries
LeakSmart
Bedford Heights, Ohio 44146
Designed in U.S.A. Made in China.
©2018 LeakSmart
®
Inc.
Customer Service: 1-855-532-5768
Technical Support: 1-855-532-5457
To learn more visit leaksmart.com
To register your product visit: LeakSmart.com/product-registration
7
Plug in AC adapter cord.
Note:
Optional 9ft extension cords are available.
AC Adapter cord input
page 4
LeakSmart® Snap FCC Compliance
FCC: W72-ZICM357SP1, IC:8254A-ZICM357SP2
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
close sync open
