Leader LV 5333, Instruction Manual, Page: 49 / 239

37
5. SYSTEM SETTINGS
F•4
F•4
5.4 Configuring the External Interface
To configure the external interface, press INTRFACE&LICENSE on the SYSTEM menu.
→ INTRFACE&LICENSE →
Figure 5-5 INTRFACE&LICENSE menu
5.4.1 Configuring the Remote Connector
You can use /P1 through /P8 of the remote connector to load presets.
To select the recall mode, follow the procedure below.
Reference 16.1, “Remote Control Feature”
Procedure
Settings
BIT:
/P1 through /P8 are assigned to preset numbers 1 through 8, and you can load
one of the eight presets.
BINARY: /P5 is set to the MSB, and /P1 is set to the LSB. You can load one of any of the
30 presets by specifying a binary value.
5.4.2 Configuring Ethernet Settings
To configure the Ethernet settings, press
menu. ETHERNET on the INTRFACE&LICENSE
The setting configured here is valid after you restart the LV 5333. They are not reset even if
you initialize the settings.
→ INTRFACE&LICENSE → F•2 ETHERNET →
Figure 5-6 ETHERNET screen
SYSTEM → F•4 INTRFACE&LICENSE → F•1 REMOTE: BIT / BINARY
F•4
F•2
SYSTEM
SYSTEM