12. VECTORSCOPE DISPLAY
107
F•3
GAIN MAG = ×1
GAIN MAG = IQ-MAG
GAIN VAR = VAR
GAIN VAR = CAL
Figure 12-7 Setting the variable gain
12.6 Configuring the Line Selection Settings
To configure the line selection settings, press
LINE SELECT on the VECTOR menu.
This menu is displayed when DISPLAY is set to VECTOR or 5BAR.
Reference
DISPLAY → 12.1, “Selecting the Display Format”
→
LINE SELECT →
Figure 12-8 LINE SELECT menu
12.6.1
Turning Line Selection On and Off
To display the vector of the selected line, follow the procedure below. You can use the
function dial (F•D) to select a line. The number of the selected line appears in the lower left
of the screen.
Changing this setting will also change the picture display and video signal waveform display
line selection settings. In addition, the selected line is linked to the picture display, CINELITE
display, video signal waveform display, and status display (data dump display).
Procedure
LINE SELECT = ON
LINE SELECT = OFF
Figure 12-9 Turning line selection on and off
VECTOR → F•3 LINE SELECT → F•1 LINE SELECT: ON / OFF
F•3
VECTOR
