4. OPERATING PROCEDURE
24
4.12.2 When set to NORMAL and AUTO SWITCHING DISABLED
Figure 4-18 NORMAL and AUTO SWITCHING DISABLED
The output signal maintains the current setting regardless of the status of the input
signal.
If you switch the SYNC SOURCE switch, the output signal can be toggled when both
the input signals are normal or erroneous. If only one of input signals is normal, the
output switches to the normal input signal. Switch to the error signal is not possible.
Normally, use the setting described in section 4.12.1, “When set to NORMAL and
AUTO SWITCHING SWITCH FAULT.”
4.12.3 When set to OVERRIDE and AUTO SWITCHING SWITCH FAULT
Figure 4-19 OVERRIDE and AUTO SWITCHING SWITCH FAULT
The operation of this combination is the same as the operation described in section
4.12.1, “When set to NORMAL and AUTO SWITCHING SWITCH FAULT.”
See 4.12.1.
4.12.4 When set to OVERRIDE and AUTO SWITCHING DISABLED
Figure 4-20 OVERRIDE and AUTO SWITCHING DISABLED
The output signal maintains the current setting regardless of the status of the input
signal.
If you switch the SYNC SOURCE switch, the output signal can be toggled regardless
of the status of the input signal.
Normally, use the setting described in section 4.12.1, “When set to NORMAL and
AUTO SWITCHING SWITCH FAULT.”
