LEAD energy PDC 30, Operating Manual, Page: 9 / 52

PDW 30 289 x 289 mm
PDC 62: 609 x 609 mm
ENGLISH
Thank you for choosing a product from LEAD energy
AG. If you would like to get in touch with our service
team, please contact them via our website or by
e-mail.
service@lead-energy.com
www.lead-energy.com
?
Intended use
You can install the PDC panels in grid ceilings or
install them as surface mounted ceiling lights or
suspended lights using the accessories that are
available separately.
Note
Please observe the warnings prior to installation.
Note that the WLAN controller for your luminaire
must be accessible for product configuration. You
can also configure your luminaire prior to instal-
lation. The settings will be maintained even if the
power supply is disconnected. Make a note of the
SSID and password of the WLAN controller.
Mounting in grid ceilings
1.1
Mounting
1
You can install your PDC in grid ceilings by replacing a
ceiling panel with the respective light panel. The size
of the ceiling panel must match that of the light panel.
Mounting in suspended ceilings
1.2
Fix the spring clips provided to your panel using the screws. Make a ceiling cut-out; the size of the cut-out can be
selected from the following list:
The cut-out must be extremely precise. The edges of the cut-out must be able to bear the weight of the luminaire.
Connect the power supply in the ceiling. Insert the panel into the cut-out in the ceiling by pressing back the spring
clips. Make sure the panel is locked fully into place.
LEAD ENERGY AG Zollhof 30 40221 Düsseldorf Subject to errors and amendments Information / Technical support: www.lead-energy.com
“Hereby, LEAD energy AG, declares that this type of equipment is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.”
https://www.lead-energy.com/innen/panel-einlegeleuchten/