WiFi
You can shorten your LED STRIP before mounting by cutting it with a pair of scissors in the places provided.
To further guarantee the IP protection class, use the silicon cap provided and the silicon adhesive to protect the
cut-off end against moisture.
WARNING:
You should
never
shorten the LED STRIP while
it is connected to the mains. Before shortening the strip,
disconnect it from the power supply, otherwise there is a
risk of injury or death.
Shorten
1
Remove dirt, grease and other residue from the surface on which you want to mount your LED STRIP before ins-
tallation. Peel the protective film away from the adhesive strip and position the LED STRIP in the required place
applying light pressure.
Mounting
2
Installation - Remote Control CD / CDW / CDC
3
Power
ON
within
15 s
1 x short
wipe
within 2 s
flashes for 3 s
SWITCH ON
(Red light
shines)
Learning Switch
1 x short
ENGLISH
LEAD ENERGY AG Zollhof 30 40221 Düsseldorf Subject to errors and amendments Information / Technical support: www.lead-energy.com
“Hereby, LEAD energy AG, declares that this type of equipment is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.”
https://www.lead-energy.com/dynamic-control