Installation instructions
Operation
Page 18 of 25
Activate/Deactivate 12-V Output
To activated or deactivate the 12-V output, perform the following steps:
1.
Press the On/Off button to open the On/Off menu.
2.
Select the menu item 'DC Out' by pressing the arrow buttons (up/down).
DC output is active
DC output is inactive
3.
To change the setting, press the OK button.
4.
To exit the menu, press the left arrow button.
The 12-V output is activated or deactivated.
Activate Jumpstart Function (Emergency Start) (12 V, DC)
With the help of the jumpstart function (emergency start), a discharged starter
battery can be jumpstarted by the LPS to such an extent that a starting process
is possible again.
To activate the jumpstart function, perform the following steps:
1.
Press the OK button to access the menu.
2.
Select the menu item '12VDC Output' by pressing the arrow buttons
(up/down) and confirm selection by pressing the OK button.
3.
Select the menu item 'Jumpstart' by pressing the arrow buttons
(up/down) and confirm selection by pressing the OK button.
4.
To activate the jumpstart function, press the OK button.
A charging current of 40 A is provided for 5 min at the DC input.
After 5 minutes, the vehicle can be started as usual.
5.
To exit the menu, press the left arrow button twice.
The jumpstart function is activated.
Device is ready for operation.
The device is switched on.
A CDR was installed (before HW version 12.20/15.20/25.20 , s.
page 14)
Summary of Contents for LPS 1212
Page 27: ......