LEAB 0101036081, User Manual

Page: 12 / 32

5 Package Contents
Item No.
Battery charger 1x
User manual 1x
6 Assembly
To assemble the device, proceed as follows:
ü
Choose a cool, dry and well-ventilated assembly site.
ü
Do not mount the device directly next to or above batteries.
ü
Guarantee adequate cooling for an unimpeded supply of cooling air.
1. Fasten the device to the side holes (5 mm Ø) on a flat surface.
ð
The device is assembled.
7 Setting the Charging Parameters
The RBC charger contains 30 different charging parameters (charging charac-
teristic, battery capacity and charging mode) which you can select before con-
necting to the battery. A graphical illustration of the charging characteristics
can be found in
Appendix [
}
22]
.
To set the charging parameters, proceed as follows:
ü
Before setting, select the desired settings using the table below.
ü
The charger is disconnected from the 230 V mains.
ü
The charger is not connected to the battery.
1. Connect the mains plug to a 230 V mains supply.
2. As soon as the 'Ready for operation' LED lights up blue (after approx. 5 s),
press the STOP button for 10 s until all LEDs are flashing briefly.
ð
You are in configuration mode.
NOTE!
When first used, charging parameters 1 (charging characteristic
LK10-06) and 9 (battery capacity 50 Ah) are preset by default.
3. To select a parameter from the list, keep pressing the STOP button until you
reach the desired position.
12 LEAB Automotive GmbH Thorshammer 6 24866 Busdorf
7 Setting the Charging Parameters LEAB Automotive GmbH