6
Operating the Stadium Hazer
Switching the Stadium Hazer on using the mains switch at the rear of the machine will instigate an automatic cleaning
routine. This cycles the Hazer through an increased temperature mode in order to purge existing fluid and any surface matter
that may be present. The machine will then switch back into a state of readiness.
Should the fluid require priming into the machine, this will occur under normal operation, but can be achieved quicker by
having the haze set to maximum output.
Site the Machine in a desired position and use the side pull latch in order to set up the required haze output direction.
*(please see acceptable operating environment conditions) * (view pictorial operational guide).
For Manual operation set the Haze switch to ‘on’ and adjust the Haze control for the desired output ( 10 steps from Zero to
Max) and adjust the Fan output for the desired distance of dispersion.
(Note that Haze output steps 1 to 5 will only use one vapour tube.. this increases the overall operating efficiency, and allows
for optimum performance)
The Fan can be set to a sweep mode by rotating the fan speed control quickly between low – high – low within 2 seconds of
Haze switch on. The highest fan speed during the sweep will be as set by the fan speed control.
DMX512 merely requires that the address of the Haze channel be set via the rotary address selector switches, (control panel)
and the correct DMX signals applied. The subsequent channel will control the Blower fan speed. Please note that the DMX
address is set at machine switch on time. Any changes should therefore be set by switching the machine off and on again.
This prevents accidental re allocation.
0 – 10V operation can be achieved by applying these analog signals to pin2 and pin3 of the external input XLR connector on
the control Panel. All control signals prioritise to that of the highest level.