The D.M.X. Interface is a replacement module for the Standard G150 Remote
Control or the Standard H175 Remote Control, which will allow D.M.X. 512
Protocol to activate the Fog/ Haze output and Flow Rate.
With Main power disconnected:
1.) Move the
Remote Mode Selector
slide switch to the
D.M.X. Positon as
indicated on the rear label.
(Pictured
Right)
2.) Remove Standard Remote control
from
Remote Cradle
(Picured Right)
and unplug 3 pin XLR input cable.
3.) Insert 3 pin XLR input cable into
Fog/Haze Machine Signal Input
(Pictured Below Right) of the D.M.X.
Interface and return it to
Remote
Cradle
.
4.)Connect Main power, and turn on
Mains On Switch
(Pictured Right).
5.) Check if the
Power Indicator
(Pictured Below Right) of
the D.M.X. Interface is
illuminated, indicating
power is present to the
unit.
Note: If the
Power Indica-
tor
is not illuminated check
that main power is present,
and the
Remote Mode
Selector
slide switch is in
the
D.M.X. Positon.
6.) Using the dipswitch,
address the D.M.X. Inter-
face using binary values (see further in this
publication) for the appropriate D.M.X. controller channel, and connect
D.M.X. Data input and output cables to D.M.X. Interface.
7.) Note if the
Data Present Indicator
(Pictured Above) of the D.M.X. Inter-
face is illuminated, indicating Data is present to the unit.
Note: The
Data Present Indicator
will flash at 1 second intervals if no data
stream is detected.
8.) Fog/Haze issue will start at 26% of D.M.X. signal, 27% -100% of the
D.M.X. signal will vary the amount of fog/haze being issued.
Using The D.M.X. Interface with your G150/H175:
