32
Installation on Mazda MX5
The launch control needs 12V when ignition is on and ground connections to power the device.
ON MX5 use CH1 and CH2 on the launch control. Other channels are not needed and can be left
disconnected.
Locate the 2 ignition trigger signals for your engine:
Early 1.6' mk1s 1989-1993 had External Igniters located on the intake side of the engine bay
on the Wing. This is instead of internal igniters inside the coil packs.
The brown and Brown/yellow can also be cut here easily as opposed to at the ECU in the
footwell.
Summary of Contents for LaunchItPro
