Rev: 07.11.2018
Page 5
CCD-0001395
Operation
NOTE:
The hitch height
MUST
be set in the memory prior to the normal operation of the Smart Jack
™.
Failure to do so will cause the Smart Jack
™
and the trailer to not function as intended.
NOTE:
To cancel an action, press either the up arrow or down arrow (Fig. 5A or 5B). The action in progress
will stop.
Setting Hitch Height Memory
1.
Press and hold the up arrow (Fig. 5A) and down arrow (Fig. 5B) at the same time for a minimum of 5
seconds to store the vertical position of the Smart Jack
™
.
2.
The battery indicator lights (Fig. 5C) will all flash 5 times to show that the new position is successfully
stored in memory.
Normal Operation
1.
Press and hold the up arrow (Fig. 5A) to extend the Smart Jack
™
.
2.
Press and hold the down arrow (Fig. 5B) to retract the Smart Jack
™
.
Return To Hitch Height Operation
1.
Press and release the up arrow (Fig.5A) and the down arrow (Fig.5B) at the same time 3 times, holding
on the 3rd time for several seconds until the jack engages and the indicator light oscillates back and
forth.
2.
The jack will automatically retract or extend to the original hitch height position.
NOTE:
Visual indication that the jack is actuating to the hitch height is seen through the oscillation of the
battery indicator lights (Fig.5C): e.g. lights will illuminate left to right, and then right to left. This will
continue until the original hitch height is achieved.
NOTE:
To cancel an action, press either the up arrow or down arrow. The action in process will stop.
Auto Retract Operation
NOTE:
This function should only be operated once the tow vehicle has been reconnected and secured to
the trailer prior to travel.
1.
Press and release the down arrow (Fig. 5B) 3 times, holding on the 3rd time until the jack engages and
the indicator light oscillates back and forth.
Fig. 5
C
A
B
